Rock Bottom Cemetery
We Know How To Scare You !!!
Head Mount Tutorial for the Numbskulls*
I know alot if you have been following the Halloween Bob Thread and are doing the Talking Numbskulls*
so I thought I would share with you a way to mount them on a PVC Frame.
I think everyone know how to make the standard Frame but if Not I will post a drawing just in case.
Instead of using the foam head tho we are going to mount the talking Skull.
You will need a PVC straight connector and connector top. you can buy this at Lowe's or Home Depot.
Drill a hole in the connector top the size of your threaded rod, slide this into the cap.Put a nut inside the cap on the rod, and on one top of the cap to hold the rod in place. get them tight as you can without breaking the cap.
then place this on your pvc neck post and screw it in to anchor it. I also put a screw in the cap top at the side of the connector to hold them tight. and there you have it plug in the prop and watch it talk.
Then you will have trouble shutting it up lol.
I Hope you Enjoy your new prop.
For those of you who do not know how to make a frame for your new props to stand.We use chicken wire and duct tape to form the body, and the legs of the pvc pipes are slide down over re-bar that has been hammer into the ground. Then he looks like he is standing on his own.The picture above is Uncle Ernie My Gravedigger.I sculpted Ernie's faces and hands.If you would like a Uncle Ernie for your own I sell them on my website at:
